Slitting Clearance Data Table
These are the starting clearance ranges used across slitter.ai, including the calculator. Clearance is the horizontal gap between the upper and lower knife, on a single side (at each cut), as a percentage of material thickness, not the total of both sides.
| Material | Thickness (mm) | Single-side clearance (recommended reference values) |
|---|---|---|
| Mild steel (cold rolled) | 0.3–0.8 | 5–8% |
| Mild steel (cold rolled) | 0.8–2 | 7–10% |
| Mild steel (cold rolled) | 2–4 | 9–12% |
| Stainless steel (304/316) | 0.3–1.5 | 4–7% |
| Stainless steel (304/316) | 1.5–4 | 6–9% |
| Aluminum | 0.5–2 | 6–10% |
| Copper and brass | 0.3–1.5 | 5–8% |
| High-strength low-alloy steel (HSLA) | Any | Mild steel of the same thickness +1–2% |
| Advanced high-strength steel (AHSS) | Any | Mild steel of the same thickness +2–4% |
| Galvanized steel | Any | Base metal of the same thickness +0.5–1% |
| Silicon steel (electrical steel) | Any | 4–6% |
Data version: 2026-11 · Updated 2026-11-09 · Reference values: use them as a starting point and confirm by test slitting. Slitting Clearance Data Table
Burr Height Limits
Common burr height limits by end use, as a percentage of material thickness. The customer's specification always takes precedence.
| End use | Maximum burr height |
|---|---|
| General structural and construction steel | ≤ 12% |
| Automotive stampings | ≤ 8% |
| Motor and transformer laminations | ≤ 5% |
| Battery electrodes | ≤ 2% |
Data version: 2026-11 · Updated 2026-11-09 · Reference values: use them as a starting point and confirm by test slitting. Slitting Clearance Data Table